MIXEDBREED
NAXJA Forum User
- Location
- Fairfield, Ca
What is a good way to trim up the rear fenders. I have a 91 XJ 3.5" w/ 32" BFG. I have the sawzaw out. Just need a little help to get started!
Thankx
Thankx
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
What is a good way to trim out the rear fenders?
- Thread starter MIXEDBREED
- Start date
avnsteve
NAXJA Forum User
- Location
- South Austin or North San Antone
CanMan
NAXJA Forum User
- Location
- Lake Tapps, WA
Take the sawzall or a Datco and cut up to the seam, every 1-3 inches. Pound up with a hammer, leaving no sharp edges. A few pics.
i did the same. used a 4.5" grinder with a cutoff wheel though. take off the lame stock fender flares and then cut up to the seam. i cut every about 2 inches and then pounded them around with a big hammer. then sprayed the inside of the wheel well with some rubberized undercoating to keep it from rusting.
- Location
- La Habra, CA
No need to make so many cuts. I only made two.
Darky
NAXJA Forum User
- Location
- 29 Palms, CA
I plan on doing them Bushwhacker style, but with the stock flares put back on.
mojojojo
NAXJA Forum User
- Location
- Gresham, Oregon
so easy a cave kid can do it....
i used some fiber glass bondo to smooth it out after beating it with a BFH. then painted and undercoated to finish it off.
i used some fiber glass bondo to smooth it out after beating it with a BFH. then painted and undercoated to finish it off.
