ok, so i want to do dr. dynos 65mm mustang throttle body conversion but my Cherokee is a renix setup. my question is: does the Renix TPS directly fit the mustang throttle body like the H.O. TPS? if anybody could shed some light on this that would be awesome, thanks:wave:
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Dr. Dyno 65mm throttle body conversion
- Thread starter jk333
- Start date
- Location
- Hammertown, USA
No.
You can bore the bottom of the renix throttle body out to 60mm. I have a bored throttle body on my renix rig and found very little if any gain, but gained a flat spot at the bottom of the throttle. Next time my throttle body comes off, the stock one is going back on.
You can bore the bottom of the renix throttle body out to 60mm. I have a bored throttle body on my renix rig and found very little if any gain, but gained a flat spot at the bottom of the throttle. Next time my throttle body comes off, the stock one is going back on.
tbburg
NAXJA Forum User
- Location
- Scottsdale AZ
This might help a little. I haven't tried any of this. My "Work in progress" is a carburated Cj, and I haven't had to mess with my XJ injection(yet)
How to modify a Mustang TB:
http://www.angelfire.com/my/fan/MustangTB.html
How to convert old to new TB:
http://www.rockmodified.com/offroad/Tech/TB/tb_perf.htm
How to modify a Mustang TB:
http://www.angelfire.com/my/fan/MustangTB.html
How to convert old to new TB:
http://www.rockmodified.com/offroad/Tech/TB/tb_perf.htm
