can I use a factory Rubi rear drive shaft on my 242?

Getting ready to do a SYE and drive shaft on my 242. I found a factory drive shaft from a Rubicon for sale. I wondered if this would be of any use to me? I have a 2000 XJ with a 242 transfer case.

I can only speak for a ruby front and it uses a 1330 ujoint and the XJ uses a 1310. May be a good time to upgrade your yokes on both ends if the length is right but the yokes put the the ujoint in a different place than the 1310's so you may wind up cutting the ruby shaft after all. I allways have good luck with local drive shaft shops. Tell them your a building a custom rockcrawlwer and they seem to get a kick out of making a shaft for sombody that appreciate a custom shaft and they will build you a nice one. They can help you with yokes that use u-bolts instead of straps too.