Quick Q...

A buddy of mine snapped a rear axle shaft last night, we ended up leaving the rig overnight cause we couldn't keep it together enough to limp it off the trail. Dana 35, c-clip, 90 XJ. Another friend has a set of shafts from a 97 ZJ, D35 c-clip, but the ZJ was ABS equipped. Will this shaft even work?

It should work, you will just have to remove the inductor ring. I don't know much about the d35's but you might want to check if the spline count changed in the later years like it did on the 8.25.

Thanks, got it apart last night, looks like the ZJ shaft will work fine.