A slave cylinder piece fell into my bellhousing

The Sealed assembly for the slave/master cylinders went on my 96. I pulled it today and the long piece that presses to engage the clutch fell down into the bellhousing. I don't really have the tools to pull everything to get it off. Someone said there is a stamped inspection plate on the bellhousing that you can unscrew and get to from that. Does anyone know where this is or if there is anyway to get this out without pulling the tranny?

IT's a little plate that is bolted to the front of the bellhousing. Get under there and look.



You can't fish it out through the slave cylinder hole?

Well I looked and I wasnt sure if thats what it was. It fell in far enough to where I cant fell it was a screwdriver. i was told to go through the dust shield cover would be easier with a magnet than the slave cylinder hole.