• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Dies once it gets warmed up....then no spark.

HaleYes

NAXJA Forum User
Location
Clay County, IL
93 XJ AW4, 4.0

Coil pickup replaced
Fuel pump replaced
Fuel pump relay replaced.

Runs fine but once it gets warmed up, it dies and looses all spark.
Let it set(cool down) and it'll run fine until it gets warmed up again.

I'm thinking PCM now. :dunno:

Any ideas.



TIA fellas.

Hale
 
did you do the CPS?
or is that what you mean by coil pickup? The one on the bellhousing or the dizzy?

easiest way to check if it's the PCM might be to disconnect the PCM's temperature sender, since it only happens warm.
 
Did you check the coil itself?

Definately sounds like a heat soak problem, usually you don't have issues with an ignition coil unless the plastic is cracked and you got it wet.

Might be worth swapping if the parts place doesn't want an arm and a leg.
 
I have owned TWO mopars (Dakota and late 80's XJ) that had the same problem and it was the pickup in the dist. both times.:compwork:
 
Just a thought...

Find the coil pack.

Remove the coil pack from the coil pack holder. The holder is what the primary wires connect to. There should be several little hex head screws that hold the pack to the holder.

Clean the contacts on the coil and the contacts on the holder where the coil and holder connect, you will see what I mean.

Rev
 
Update for those who search:

Problem was solved with a new CPS.(crank position sensor)

Hale
 
Back
Top