Anyone have access to a lathe?

[karstic]

Just as the title says.

[forcefed]

yes, a good buddy of mine owns a fab shop next to john wayne airport in irvine, it took him 5 min. to do drill and tap 2 sides of a tube. What do you need done?

[silverslk]

I work at a shop with a lathe too and a bunch of other equipment I don't know how to use,haha. What do you need?

[zjmikey]

We have 2 48" acraturn lathes and 2 48" bridgeports..


What do you need done???

I am in orange

[sintax]

I need a V-belt York pulley milled down into a flat surface so it accepts a serpentine belt.

Could you guys do that Mikey?

[JohnX]

I need a V-belt York pulley milled down into a flat surface so it accepts a serpentine belt.

Sweet!

You need grooves? Seems like if you run it on the back side of the belt, slipping might be an issue.

[zjmikey]

I need a V-belt York pulley milled down into a flat surface so it accepts a serpentine belt.

Could you guys do that Mikey?

Dude! that's cake..

no problemo..

I am going out of town in the morning so 1st part of next week is open.

Let me know

Shoot me a PM.. I will send you my PH#

[sintax]

Sweet!

You need grooves? Seems like if you run it on the back side of the belt, slipping might be an issue.

I'm planning on running it in the same place as the factory Sanden compressor, this would mean that it runs on the grooved side of the belt. It should not be much of a challenge to groove it a bit either.

[sintax]

Dude! that's cake..

no problemo..

I am going out of town in the morning so 1st part of next week is open.

Let me know

Shoot me a PM.. I will send you my PH#

Sweet. I work in Santa Ana. I'll PM you.

I dont need it done ASAP so its not a big worry.

[karstic]

We have 2 48" acraturn lathes and 2 48" bridgeports..


What do you need done???

I am in orange

Mike I've got something lined up. If that doesn't work out I'll get in contact with you.

[jeeperjohn]

Me too! I just need to find a set of rings and gaskets for a Tecumseh pump. Anybody got any connections?