PDA

View Full Version : Renix/storker/injector question

traitor5150
February 19th, 2007, 19:37
Ok Im building a Renix stroker. What in injectors can I use I hear everyone saying mustang but does that apply to all jeeps or just HO??? I read somewhere that injectors off a mid 90's dodge/jeep 5.2 will work if so on the Renix and what year truck/jeep do i need them out of.
Bender
February 20th, 2007, 05:48
Here is a list of injector specs from Dino Savva on this site...

http://www.jeep4.0performance.4mg.com/tech_specs.html

If you going with the low budget stroker you'd probably be fine with some injectors out of a 1991-1995 HO 4.0L as they have more flow than your current RENIX units.

When I built my low budget RENIX stroker I went with the ACCEL 24# units but they rate their flow at a higher psi than the stock ones so they actually only flow 23 #/hr at 39 psi. This gives me sufficient fuel delivery.

Another person I wheel with has a higher hp stroker based on a RENIX engine that uses the 91-95 HO 4.0L injectors but has raised his fuel pressure to 49 psi. This would increase the flow from the stock 21 #/hr to 23.5 #/hr. His setup seems to run better than mine but his internals are different as well.
Flash
February 20th, 2007, 14:22
which ones are a plug and play inj and which ones have to have a connector swap and wire splice? or do they all (in the list or link above)us the same connector????????



flash
traitor5150
February 20th, 2007, 16:49
which ones are a plug and play inj and which ones have to have a connector swap and wire splice? or do they all (in the list or link above)us the same connector????????



flash

Yeah thats what i need to know too
Bender
February 20th, 2007, 18:02
All the injectors listed on dino's site use the same connector.
Dr. Dyno
February 20th, 2007, 23:20
Ok Im building a Renix stroker. What in injectors can I use I hear everyone saying mustang but does that apply to all jeeps or just HO??? I read somewhere that injectors off a mid 90's dodge/jeep 5.2 will work if so on the Renix and what year truck/jeep do i need them out of.

You can use the Ford Racing 24lb/hr injectors or the equivalent of the 24lb injectors that came in the 5.0 Mustang Cobra. I have the former in my HO stroker and they work great. Since yours is a Renix stroker, the only thing you might need to do is install a MAP adjuster and set the voltage lower than 5.0v to lean the injectors out a little.