aszaunmi
February 8th, 2007, 09:04
Hey all,
I have a solid steel rod ~7/16 inch thick and about 18 inches long that needs to be bent a couple times. The instructions want me to heat it with a torch and then bend it with a hammer and vice. I could do it that way but I would rather pay a few bucks or donate some beer if someone with a bender can help me out.
Anyone in the East Valley (I am in East Mesa) have a bender that is willing to help out?
I might actually get my jeep rolling today and head over to Desert Fab to get shocks and talk to them about my EXO. If nobody else can help out with the bending of the rod I may ask them if they have the time to do a couple of quick bends..
Andrew
I have a solid steel rod ~7/16 inch thick and about 18 inches long that needs to be bent a couple times. The instructions want me to heat it with a torch and then bend it with a hammer and vice. I could do it that way but I would rather pay a few bucks or donate some beer if someone with a bender can help me out.
Anyone in the East Valley (I am in East Mesa) have a bender that is willing to help out?
I might actually get my jeep rolling today and head over to Desert Fab to get shocks and talk to them about my EXO. If nobody else can help out with the bending of the rod I may ask them if they have the time to do a couple of quick bends..
Andrew