Hood Vents - Part II

[Dawg Cherokee]

http://www.hpphoto.com/servlet/LinkPhoto?GUID=3efe23f4-1298-47ab-411d-10cef73c2ef0&size=lg

http://www.hpphoto.com/servlet/LinkPhoto?GUID=4f1f1168-6fe8-552e-71cd-1edc21e72acd&size=lg

http://www.hpphoto.com/servlet/LinkPhoto?GUID=53b8624f-3c2c-1d4f-29f7-65d546307d0d&size=lg

Here is how the Dawg looks after the vents were added. I have had them on for about a month now. Judging by the lesser number of times that I have had to turn on the 2nd fan, there seems to be a noticable improvement in cooling at all speeds.

Step 1: Bought Leer medium sized hood scoops and cut out the fake inlets. (Painting is optional)
Step 2: Cut three 3" holes on each side of the hood, around supports.
Step 3: Mount scoops facing backwards, using pre-attached two-sided tape.
Step 4: Go wheeling

Don't put too close to wondshield, or you will have an unwanted cowl induction effect and /or hot air going into your vent.

(Hopefully the photos will work)

[KarmirXJ]

those vents look like they belong on a civic:D

but nice job anyway looks good.

[Rev Den]

I like them!! but, any reason why you did not switch the sides? So the tapers, taper out?

Just asking.

Rev

[Dawg Cherokee]

By putting the reversed scoops on this way, the air from the two vents moves out towards the sides instead of concentrating together up the middle of the hood.