chris_amrein
NAXJA Forum User
- Location
- fullerton
I tried searching but couldn't find an answer...
Has anyone used a SYE and a non-CV driveshaft. I plan to do about 4.5" - 5" worth of lift in the rear and swap in my new Dana 44 at the same time.
I have been told that if the output of the transfer case and the axle pinion are at the same angle that I will not get vibration. Is this true? It seems that I should be able to run a non-CV shaft because an XJ has a long wheelbase.
Thanks, Chris
Has anyone used a SYE and a non-CV driveshaft. I plan to do about 4.5" - 5" worth of lift in the rear and swap in my new Dana 44 at the same time.
I have been told that if the output of the transfer case and the axle pinion are at the same angle that I will not get vibration. Is this true? It seems that I should be able to run a non-CV shaft because an XJ has a long wheelbase.
Thanks, Chris