woodywagon
NAXJA Forum User
- Location
- ft. wayne in
Anyone know how to adjust TPS on 87 renix engine?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
TPS adjustment
- Thread starter woodywagon
- Start date
Dr. Dyno
NAXJA Forum User
- Location
- Al Ain, UAE
This subject's been discussed at least 100 times so I suggest you do a search in this forum and on Google. 
langer1
NAXJA Forum User
- Location
- Mineral City,Ohio
At least he posted the year.Dr. Dyno said:This subject's been discussed at least 100 times so I suggest you do a search in this forum and on Google.
anony91xj
NAXJA Forum User
- Location
- North Jersey
Key on, engine off. Work with the 3-pin connector, the 4-pin goes to the auto trans controller (there is no 4-pin connector if you have a 5-speed). First check for a 5v reference signal between pins A and B on the harness connector, make sure that's OK, then connect the new sensor.
Then, with the sensor connected (key on, engine off still), backprobe pins B and C, you want to adjust the TPS until you get 0.8v there with the throttle plate closed. If you cannot achieve the 0.8 volts, replace the TPS.
Then, with the sensor connected (key on, engine off still), backprobe pins B and C, you want to adjust the TPS until you get 0.8v there with the throttle plate closed. If you cannot achieve the 0.8 volts, replace the TPS.
