Ford 9" 4.10 pumpkin

Ok here are the specs... Its only 6 months old and just been broken in... aprox 2500 miles..

Strange Engineering Aluminun case - 3.062 carrier bearings
Strange Engineering Aluminum Daytona pinion support
Detroit True Trac unit - 31 spline
4.10:1 gear ratio from DC4X4 - claims to be richmond
Ford 28 spine small yoke
Speedway Viton pinion seal
Strange Pinion kit with solid preload spacer
All Timken bearings


Ok I am not willing to seperate or part this unit out.. I have over 1400$ in just parts alone. I consider this a deal at $1000.00 FIRM.... I will ship to lower 48 only for freight costs and $50.00 crate fee... I prefer some one local... If you don't want 4.10's let me know or buy some gears and I will set them up for you at no cost... this is better built than a currie and less money... Thanks for looking...

Scott.

SOLD!!!

Was it the good looking one you were building last year?

yep that was the one...just the 3rd member tho...the axle is still under the jeep with the new-used gears and locker...