xjdavid1
NAXJA Forum User
- Location
- Brisbane Australia
Has anybody fitted spacers under the engine mounts to improve the driveshaft angles if so what size is the maximum that will fit.
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Spacers under engine mounts
- Thread starter xjdavid1
- Start date
CanMan
NAXJA Forum User
- Location
- Lake Tapps, WA
You would still have the tranny mounted, so I dont see that adding shims under the engine mounts would do any good. Thats just .02.
Skullver
Still Flailing
- Location
- Ventura,CA
They make raised motor mounts, dont know if it would be a great idea, as you may go through tranny mounts faster. It would be easier to drop crossmember to improve angles, same end result but much easier to remove.
smilesyota
NAXJA Member #1366
- Location
- Tewksbury, Ma
this would improve the rear drive line angle but hurt the front out put. Also it would not lower the t-case, so it would not be hanging down any lower a bonus in my book.
Frank Z
NAXJA Forum User
- Location
- Colorado Springs
What?robz95xj said:
planefixer
NAXJA Forum User
- Location
- Colorado Springs, CO
Frank Z said:
"seeing you're lifting your motor"..............I think.
