Fog light install. Wheres the high beam wire?

I am looking at my new fog lights and i can figure out how to run all the wires expect one that is suppose to hook up to the high beam switch. Does anyone know where that wires is? I dont know much about electrical at all. Is there some where else i can run that wire to?

If you're doin' fogs, then you should be using the low-beam not high-beam.

You can trace it back from the headlamps. There is a connector near the airbox that has what you need.

Basically, low-beam(via fuse) to one side of the relay coil, other side of the coil to the switch, other side of the switch to ground.

Do a search. there's got to be a diagram somewhere around here.

This should help...

http://www.rallylights.com/useful_info/headlamp_wiring.htm