sjan
NAXJA Forum User
- Location
- LITTLEROCK,CA.
what glue should i use to glue the rubber hockey pucks inside coil springs to make bump stops ?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
hockey puck bumpstops
- Thread starter sjan
- Start date
jeepinandy
NAXJA Forum User
- Location
- SWVA
Some people use epoxy to hold them in but it breaks loose after a while IIRC..
Most just drill and tap a hole and bolt them in.
Most just drill and tap a hole and bolt them in.
flash_gordon
NAXJA Forum User
- Location
- Colorado Springs
I used gorilla glue. Stayed put for around nine months until I had to pry them off to change springs.
Shawn
Shawn
sjan
NAXJA Forum User
- Location
- LITTLEROCK,CA.
Thanks !
rokclimbertx
NAXJA Member #1267
- Location
- Gainesville, TX
black rtv has mine in there very solid... be sure and score the surface of the pucks so they stick better
sjan
NAXJA Forum User
- Location
- LITTLEROCK,CA.
Thanks Maxwell
FRAM
NAXJA Forum User
- Location
- Pacific North North West
My god. Pucks are for Hockey!!!
rokclimbertx
NAXJA Member #1267
- Location
- Gainesville, TX
not when it comes to USA hockey this year...
FRAM
NAXJA Forum User
- Location
- Pacific North North West
Sadly the same for Team Canada too. They shit the bed.
