PDA

View Full Version : nth* adj ca's

phurealdeaux
February 14th, 2006, 18:45
nth* adj ca's as advertised are rh and lh threaded for "on rig" adjustability. is this safe? does anyone use these?
XJ_ranger
February 14th, 2006, 18:56
nth* adj ca's as advertised are rh and lh threaded for "on rig" adjustability. is this safe? does anyone use these?

if they are anything like the rear uppers for the TJ, id shy away... I was not impressed with the bushing life and apparent strength that they had...

do youself a favor - buy some JKS arms...

On vehicle adjustablity is great, but how many times are you really under there adjusting them anyway?

it not like your pumping gas, then suddenly remember "Oh my, i havent adjusted my control arms recently"

its a set it and check for tightness thing...
GirlScout1
February 14th, 2006, 19:13
I had them before I went to LA and loved them. Never had a problem with bushings and they were easy to adjust. When I finally got it right where I wanted them I gooped on some Loc-Tite and cinched them down good. I would but them again.
Kittrell
February 14th, 2006, 19:15
it not like your pumping gas, then suddenly remember "Oh my, i havent adjusted my control arms recently"

I do that all the time, don't you?

:D
phurealdeaux
February 15th, 2006, 00:13
so, that's one yea, one nay and and one uhhhh...... anyone else?
Kittrell
February 15th, 2006, 04:27
so, that's one yea, one nay and and one uhhhh...... anyone else?

I don't think to many people have them. They don't make a whole lot of XJ parts. And these just happen to work with XJs as well as TJs, which is their main demographic.
a_hiatt
February 15th, 2006, 05:19
haven't ran the specific arms, but i am a big fan of on-rig adjustability. my steering/trac bar setup is all lh/rh threads.