Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
Any writeups on this or is this pretty straight forward? I did search and found very little info. Just pry out the seal, use bearing puller and installer to install new bearing and seals? Any other info I might be missing? Thanks Jeff
use an 8mm 6pt combo wrench. do not use a 12pt socket or combo as its very common to round the crosspin bolt.
I also find alot of times thats its easier to cut the old bearing out rather than try and pull it out. I mean I have lots of practice at using a slid hammer, but even I get tired. :wierd: :rattle:
push a rag into the tube before you cut/pull. That will keep bearings from going in further than you wanted.
inspect the shafts for galling and pitting.
have fun. should take you no more than an hour.