D44 teraflex disc conversion????

9

97trxuszj

NAXJA Forum User

Location

Auburn, WA

• Jan 3, 2006

• #1

I did this swap on a 89 xj rear d44 and I used stock everything there was no special spacer or anything with the kit I got longer studs and pressed them into the shafts kept the stocks shafts bearings and seals, well after its all together my axles on both ends are spraying and dripping 80-90wt out of the ends what could be the problem just seals? what should I do?

 

B

bigwhitey

NAXJA Forum User

Location

Brunswick, ME.

• Jan 3, 2006

• #2

Even with new seals mine leaked real bad. Clean out the outer flange of the tube where the seal should seat and add some gasket sealer/ diff sealer/ or what ever you prefer. Mine has'nt leaked since.

 

M

MGrobe

NAXJA Member #968

Location

Chicagoland-area, IL

• Jan 3, 2006

• #3

When I did mine on an 87 D44 axle I did put in new seals. Haven't had any problems with leaking the last 2+ years.

 

9

97trxuszj

NAXJA Forum User

Location

Auburn, WA

• Jan 3, 2006

• #4

what disc did u guys use? tera or ZJ? also any special retaining plates?

 

B

bigwhitey

NAXJA Forum User

Location

Brunswick, ME.

• Jan 3, 2006

• #5

I used ZJ with rubicon retaining plates.

 

M

MGrobe

NAXJA Member #968

Location

Chicagoland-area, IL

• Jan 3, 2006

• #6

I used Tera's kit.