Speedo gear change

[Mike from Chile]

With the help of muy good Naxja friend EAGLE, i got the 31 tooth speedo gear. When firts installed, went for a testing ride and speedometer did not move and yellow engine light turned on. I disarmed it and rotate it a little bit and went for a second test ride. Good news speedometer worked but engine light kept on.

Do I need to go to a service so they connect it to the computer reader?
Can I drive with no damaging danger?

Thanks from Chile

Mike

[RNMedic]

try disconnecting the battery for a couple of minutes. Not sure if this works on the later models though, just a suggestion, John

[anaheimxj]

also after a certain number of times starting the jeep without any sensor problems it should go away on its own.

I had my ehhaust system out and the O2 sensors disconnected.
When I put it all back together the "CHECK ENGINE" light came on. After I think 7 "clean" starts it went out.

Disconnecting the battery is probably the quickest, but if you don't want to loose memory here is another way.

[Mike from Chile]

Thanks to everyone. Problem was solved by disconnecting battery for one minute.
Now I can realize that I was enjoying too much driving 10 miles over the speed limit.
hahah
Bye

[Eagle]

Mike --

Did you check the new gear for accuracy? How close is it now to Andrea's speedometer?