sheet metal gauge question

ok so while getting angry with the guy that put torx bolts on just about every single fastener... i had the brilliant idea to look up and see my roof from under the jeep.(once i moved some insulation that is....) so my question is this... what gauge sheetmetal are you guys using?( namely muduck)

i've helped friends out installing floorpans before but i have been fortunate enough in the past to have NOS stuff. unluckily for me i havent found anywhere that would carry these for an XJ so i'm making my own.

but on the brighter side if i drop something while sitting at a light i dont have to get out to pick it back up! on the not so bright side... i havent seen that many cases of cancer in a chemo ward!

Here you go: http://shermanparts.com/page.php?content=inside&more=news&PartID=14 .........Hans

thanks for the link hans... but would ya happen to have a line on trans tunnels too?

I used 18g and am quite happy. It is a bit thicker then stock and I like it that way.

katarn