Junkyard Tranny Cooler done...

[Gil BullyKatz]

While getting some replacement glass for the heep...

I picked up a Ford Econoline Tranny cooler for $10...

Completely bypassed the radiator cooler...

Cut the hard lines and hooked the hoses up...

I did some creative cutting behind the grill so that there's a 2" space between the tranny cooler and the AC condensor...

The grill still fits fine...

http://img.photobucket.com/albums/v465/bullycatz/jeep/DSCF0005.jpg

http://img.photobucket.com/albums/v465/bullycatz/jeep/DSCF0006.jpg

http://img.photobucket.com/albums/v465/bullycatz/jeep/DSCF00071.jpg

Got too dark to take pics of the grill installed...

I'll post them later with observations from the daily highway crawling...

edit: tranny cooler on pass side/steering pump cooler on driver side

[Thayer]

Did you just slide the rubber hose right over your cut hardlines?

[DeftwillP]

Power steering on the driver's side?

[Rev Den]

Gil....you continue to amaze me. Talk about making common sense mods on a low budget....you sir are my hero.

Nice job.

Rev

[rangerjoe2001]

Good stuff!

[Gil BullyKatz]

Did you just slide the rubber hose right over your cut hardlines?

Yes... Spent $15 on 5' of Goodrich tranny fluid lines



Power steering on the driver's side?

Yes...


Gil....you continue to amaze me. Talk about making common sense mods on a low budget....you sir are my hero.

Nice job.

Rev


Thank you very much...

"Improvisation born of necessity"

The Barrio Fabworks new slogan



btw... I haven't decided on keeping the AC for next year or going with a sweet OBA like yours...

and I still have to swap the HP44 under the front and finish the forced induction stroker...

and chopping the rear...

etc etc etc...

[w_howey]

Nice job bro!

I owe you a cold for my blatant theft of the Barrio Fabworks door latch.

Did you put any kind of flare on the hardlines at all?