TrailSport wheel spacers, studs to long!

i have a set of wheel spacers, but the studs that are on my yukon shafts are a bit to long, the wheels won't sit flush on the spacers, can i reuse old wheel studs, or are they no good once you knock them out? because i still have the ones on my stock shafts and would like to use them, and can the studs be knocked out while the shafts are still in?
thanks for any help.

well, thanks...i just ended up getting new studs, all is well..:laugh3:

Probably better with new ones. I would imagine the old would work but when in doubt....

I had a similar problem when I went to put my spidertrax ones on my 8.8. All I did was cut a bout a 1/4" off with a cutoff wheel. I hope you used Loctite on the wheel studs when you installed them.



Patrick