HELP.. with torque converter bolt up

I just pulled and replaced the motor in a 90 and now that the motor is bolted back in, how do I get the torque converter to turn so that I can line up the bolt holes with the flexplate?? With that daym tone ring on the flex plate I cant reach behind it and and even touch/fell the converter.

Help....

PS I knwo this is posted in three forums but I really need help by tomorrow morning as I want to finish this up tomorrow.

leave the starter off, and reach behind the flexplate in the starter hole. It is big enough to get your fingers in there and turn the converter

turn the flywheel using a big wrench on the crank