I'm trying to mount my Bushwhacker flares on the rear end and can't figure out how they go on. Can anybody help ? A pix would be great! Thanks. Email pix to [email protected]
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Bushwhacker flares...need advice mounting
- Thread starter XJulie
- Start date
Georgia Mike
NAXJA Forum User
- Location
- Flowery Branch,GA
Need more info. 4 door? 2 door? Have you cut the fenders out yet? Please be a little more specific,and I'm sure lots of folks will chime in to help ya out! Welcome to 
! 
! 
- Location
- San Bruno, CA.
Jason West has a good install write up here...
http://www.jeepin.com/features/bushwacker/index.asp
HTH.
Jes
http://www.jeepin.com/features/bushwacker/index.asp
HTH.
Jes
I had no problem what so ever installing my Bushwackers - Only trick is to trim a little at a time till they fit nicely.. good luck
see the gap between the rear flare and the small cover piece?
this allows for the flare that is attached to the door to fit in there and let the door close,, i cut that gap,, about 3/8" off the cover piece.
I held the flare up to the molding and marked a line, then cut it with a hack saw,, then pryed it off wiht a flathead screw driver..
see the gap between the rear flare and the small cover piece?
this allows for the flare that is attached to the door to fit in there and let the door close,, i cut that gap,, about 3/8" off the cover piece.
I held the flare up to the molding and marked a line, then cut it with a hack saw,, then pryed it off wiht a flathead screw driver..
