Transfer case drop installation Q's

OK, looked around and couldn't find anything so I'll post- I'm about to put a Rusty's T-case drop crossmember in to take care of some (very slight) vibes after installing the OME 934's and JC1A/MJ shackle. Will I need to adjust the transfer case shift linkages and transmission shifter linkages (as well as the kickdown)? I'm running a 242 in an '01 XJ. Rusty's page says you get about a 1" drop with no loss of clearance..... TIA

Nope - they should be fine. You know about the two studs you'll find holding the stock crossmember in place, right? http://www.yuccaman.com/jeep/tcase.html

Yep. I do. I'm hoping since Rusty claims it's a direct bolt in replacement I won't have to go through your pain.... ;-)

While you're under there, I'd recommend removing the studs and putting a new set of four M10x1.50 bolts...I think stock is something like 30mm long. It's easier to do that now than a year or more down the road when they're frozen in place anyway.