5-90
NAXJA Forum User
- Location
- Hammerspace
Just went and got a set for my 88 - same bearing services the upper idler pully and the A/C Delete Pully.
Part number is #203FF (Timken.)
I'm sure this will work for RENIX - not so sure above that.
My bearing measurements were:
0.472" thick at widest part of outer race
1.574" outside diameter (slight press fit - probably .0010-.0015")
0.668" inside diameter
I've been asked this before, and I've finally gotten round to finding out. For all of you who find this useful - you're welcome.
Confirmation of suitability of part on later models desired - please PM or post.
5-90
Part number is #203FF (Timken.)
I'm sure this will work for RENIX - not so sure above that.
My bearing measurements were:
0.472" thick at widest part of outer race
1.574" outside diameter (slight press fit - probably .0010-.0015")
0.668" inside diameter
I've been asked this before, and I've finally gotten round to finding out. For all of you who find this useful - you're welcome.
Confirmation of suitability of part on later models desired - please PM or post.
5-90
