HAPYMUDY
NAXJA Forum User
- Location
- Western New York
Wondering if the Cherokee FSM has the cross-sectional dimensions of the "rocker" body for a 2000 Cherokee. I am looking to fabricate a rocker guard out of some 5" plate steel (or so) and wondering if anyone has these dimensions at their disposal.
Looks like it's about 4 - 5 inches from the pinch seam up to where you'd want to end a rocker guard. The bends are not 90 degrees, more like two bends -- the most important would be the 120 degree (guess!) or so bend that will lay somewhat flat on the face of the rocker.
Just a thought at this point.
Looks like it's about 4 - 5 inches from the pinch seam up to where you'd want to end a rocker guard. The bends are not 90 degrees, more like two bends -- the most important would be the 120 degree (guess!) or so bend that will lay somewhat flat on the face of the rocker.
Just a thought at this point.