nate
NAXJA Forum User
- Location
- Anchorage, Alaska
Well I was told to post here by the mods instead of the For Sale forum... so here's the post
Machined out of 1018 mild steel, $10 ea, $1 ea for shipping.
What you do is drill out your driver's knuckle to 3/4" and put the insert in place. You can run a few tack welds on it to hold it in place, but you don't have to.
What this does is allows you to put your tie rod on top of the driver's knuckle. Higher up... less chance of slamming it on rocks. My brother is the one that makes these, he is a machinist.
Nate
PM me, [email protected], or 907 830 2812 (10AM-10PM AK time).
Machined out of 1018 mild steel, $10 ea, $1 ea for shipping.
What you do is drill out your driver's knuckle to 3/4" and put the insert in place. You can run a few tack welds on it to hold it in place, but you don't have to.
What this does is allows you to put your tie rod on top of the driver's knuckle. Higher up... less chance of slamming it on rocks. My brother is the one that makes these, he is a machinist.
Nate
PM me, [email protected], or 907 830 2812 (10AM-10PM AK time).