Need a Dana 30 Measurement PLEASE

[HotwheelsYJ]

I am canning the disco and putting in one piece axles.
I already have seals in place and axles in it.

I ran off and left the disco laying @ home with the measurements.

Can someone measure the size that the block off plate needs to be?
width X length & hole centers for me?

Thanks, I really want to make this plate and get this project finished tonight.

[HotwheelsYJ]

Anybody??

[pbandj]

WOULD SOMEBODY HELP THE MAN ALREADY!!
(I would but my d30 has no disconnect motor)

[woody]

I am canning the disco and putting in one piece axles.
I already have seals in place and axles in it.

I ran off and left the disco laying @ home with the measurements.

Can someone measure the size that the block off plate needs to be?
width X length & hole centers for me?

Thanks, I really want to make this plate and get this project finished tonight.

OKOK... my scanner is acting up but I have the #s if the pic isn't legible.
http://www.sb-host.com/imagehost/showphoto.php?photo=1181&password=&sort=1&cat=3005&page=1

[woody]

Overall width 117mm, overall height 114mm.

6-7mm hole diameter.

(4) top & bottom holes: 39mm on horizontal center, 99mm on vertical center.

(2) middle holes: 94mm on horizontal center, and 45mm up or down from the HCs of top & bottom.

This was made for me by a good friend/Member out of 5mm aluminum. The only "contour" I'd worry about - if building my own - would be the lower third.

HTH & get to work!

[JJacobs]

Why not just put the vacuum motor back on? The fork doesn't even need to come out, it won't hit the axle.