Heb80
NAXJA Forum User
- Location
- Harrisburg, PA
Can anyone confirm what size the nut is on the end of the Chrysler tool C-4164?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Chrysler axle and Tool C-4164
- Thread starter Heb80
- Start date
2offroad
NAXJA Forum User
- Location
- Concord NC
what is the tool used for?, if it for adjusting an 8.25 rear it is 36mm.
Heb80
NAXJA Forum User
- Location
- Harrisburg, PA
2offroad said:
Thanks... Yeah its for an 8.25... from what I've heard its the same tool for all of the Chrysler axles though.
2offroad
NAXJA Forum User
- Location
- Concord NC
we made a tool out of 36mm nuts and tubing and 3/4 nuts.
Wil Badger
NAXJA Forum User
- Location
- Utah
find two front axle nuts they are 36 mm.weld them to a rod and your done.
