binfordtools
NAXJA Forum User
- Location
- Michigan
This a factory 9.25 axle from a 1999 Dodge Ram. The axle has around 3800 miles on it. I swapped it right when I got my truck for a 4.10 axle that we had built up. The thing is basically brand new and has been stored in my dad’s heated garage since the summer of 1999.
Here are the specs:
9.25 axle
3.55 gears
complete (minus drums)
62" from backing plate to backing plate
5" from backing plate to end of stud
Not sure how hard this would be to swap into a Jeep or some other project, but I though I would post it here to see if anybody would be interested. I’d like to sell it for around $200.00. Located in Oak Park Michigan if you would like to come take a look.
Here are the specs:
9.25 axle
3.55 gears
complete (minus drums)
62" from backing plate to backing plate
5" from backing plate to end of stud
Not sure how hard this would be to swap into a Jeep or some other project, but I though I would post it here to see if anybody would be interested. I’d like to sell it for around $200.00. Located in Oak Park Michigan if you would like to come take a look.