jeepguy97
NAXJA Forum User
- Location
- clearfield, pa
How do these attach? Pinch weld and frame? Welding necessary?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
C4X4 rock slider attachment?
- Thread starter jeepguy97
- Start date
- Location
- La Habra, CA
Yes...pinch seams and "frame". No welding. Very strong. I've taken some heavy hits on mine.
- Location
- Lafayette, CA
When they are bolted to the frame, do the bolts go all the way through? or is it tapped and threaded? Also, the pinch seam that is being talked about here is below the door? Or is that something else?
- Location
- La Habra, CA
Yes, the pinch runs underneath from wheelwell to wheelwell.
As for the bolts that mount to the frame, I think they are self-tappers. It's been so long, I can't remember. But now that I think of it, they would have to be self-tappers.
As for the bolts that mount to the frame, I think they are self-tappers. It's been so long, I can't remember. But now that I think of it, they would have to be self-tappers.
jeepguy97 said:
Front are self-tapping into the side of the frame-rail. Rear is nut and bolt through the rear spring hanger. You can put a nut on the bottom of the two front bolts - there's a hole in the frame rail that will allow you to fit a lock washer & nut so that you can minimize the risk of pulling the other self-tapping bolt out.
