ARB Question

I just put in a ARB in the rear Dana 35. I have the compressor installed and the switches. What I need is a photo of what the line fittings look like. I don't have any directions because the locker was bought already set up in the axle with 4.10 gears for only 400 bucks. The down side was that there wasn't any lines or fittings just the bulk head fitting. Any help? Thanks Juice

Thats a tough one to explain,I dont have a scanner so.....Other than the bulkhead fitting everything else is 3/16" compression fittings.It basically is two couplings,with one-half of each from each side of the bulkhead fitting!