98XJ
NAXJA Forum User
- Location
- Duvall, WA
I have blown right side hub (internal sleeve slines stripped). I noticed engagement between slave sleeve and dog sleeve is about 2-3/32 which I think is not enough. I have standard hub conversion 5X4.5 from MileMarker. Will Warn standard lockout hub fit?
What goes south in Warn lockout hub when it blows?
Also, If any one knows what is a normal spline engagement between dog sleeve and slave sleeve inside the hub (not stub axle splines) of Warn standard hub (if that has been measured)?
Thanks!
What goes south in Warn lockout hub when it blows?
Also, If any one knows what is a normal spline engagement between dog sleeve and slave sleeve inside the hub (not stub axle splines) of Warn standard hub (if that has been measured)?
Thanks!