95 Steering Column Shroud

M

MikeU

NAXJA Forum User

• Jan 1, 2005

• #1

I hope this not to dumb a question but how does the steering column shroud come off on the 95 XJ. There is one torx screw in the middle on the bottom and two holes but I can not tell what it takes to seperate the two halves of the shroud.
Thanks
MikeU

 

Wayne Sihler

NAXJA Member

NAXJA Member

Location

Maurertown,Va.

• Jan 1, 2005

• #2

Should be 2 screws.one each in the recessed holes .i guess that the center screw drops the bottom off,the outers let the top come off.
Wayne

 

M

MikeU

NAXJA Forum User

• Jan 1, 2005

• #3

Are the screws in the recessed holes torx screws or philips?

 

Wayne Sihler

NAXJA Member

NAXJA Member

Location

Maurertown,Va.

• Jan 1, 2005

• #4

MikeU said:

Are the screws in the recessed holes torx screws or philips?

Click to expand...

Torx,IIRC same as the middle.
Wayne

 

G

GodSpeed

NAXJA Forum User

Location

State College, PA

• Jan 2, 2005

• #5

I just had mine off today...al three must come off and yes they are all the same size torx....


Peace..........................BartG

 

C

Chancer

NAXJA Forum User

Location

Bonnie Scotland

• Jan 2, 2005

• #6

IIRC, you have to remove the ignition barrel by turning it to start and then pushing in a clip. Buggered if i know where to find it though.

 

Matthew Currie

NAXJA Member #760

Location

Vermont, land of big clay

• Jan 2, 2005

• #7

Chancer said:

IIRC, you have to remove the ignition barrel by turning it to start and then pushing in a clip. Buggered if i know where to find it though.

Click to expand...

Not on the 95. Those 3 screws should do the trick.