MyBlackJeep
NAXJA Forum User
- Location
- Golden, Colorado
my ignition is about dead. i was wondering if any of you guys put in and aftermarket ignition and what brand, thoughts and feeling about certain brands,
thanks
kenny
thanks
kenny
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
New ignition
- Thread starter MyBlackJeep
- Start date
8Mud
NAXJA Forum User
- Location
- Central Germany
IMO oppinion the OEM ignition works just fine, other than the small diameter cap that is prone to crossfire, when the inside gets dirty from from burnt carbon and oxides from normal wear and tear.
I really don´t know if a kit to increase the diameter of the cap and rotor are worth the money, caps/rotors are cheap and can be replaced often.
A good set of wires sure can´t hurt much, but the coil to cap wire, together with the OEM module, seems a little sensitve to the resistance (ohms) in that cable. I´ve had better luck keeping the coil to cap wire stock.
I really don´t know if a kit to increase the diameter of the cap and rotor are worth the money, caps/rotors are cheap and can be replaced often.
A good set of wires sure can´t hurt much, but the coil to cap wire, together with the OEM module, seems a little sensitve to the resistance (ohms) in that cable. I´ve had better luck keeping the coil to cap wire stock.
Gridikal
NAXJA Forum User
- Location
- Sidney, NE
Dr. Dyno says the stock ignition is fine with an upgrade being plug wires.
