Johnny V
NAXJA Forum User
- Location
- Jersey Shore
Hi All,
I'm getting ready to install fuel injectors that I purchased from FiveMotorsports - the 19 pounders for my '89 in-line-six. There are tan caps on the injectors - on the nozzle end - and I'm not sure if they are shipping caps or part of the injector. Here's a picture of the new one. New one is center and two old ones I pulled out. The left one is the original and the right one was installed a couple of years ago.
http://home.comcast.net/~johnnyv/injector_cap.jpg
There is a previous thread on this but wasn't sure what was the final consensus.
http://www.naxja.org/forum/showthread.php?t=38139
I tried pulling one off with a pliers and it's hard as a mother to pull off.
Thanks for your help!
John V
I'm getting ready to install fuel injectors that I purchased from FiveMotorsports - the 19 pounders for my '89 in-line-six. There are tan caps on the injectors - on the nozzle end - and I'm not sure if they are shipping caps or part of the injector. Here's a picture of the new one. New one is center and two old ones I pulled out. The left one is the original and the right one was installed a couple of years ago.
http://home.comcast.net/~johnnyv/injector_cap.jpg
There is a previous thread on this but wasn't sure what was the final consensus.
http://www.naxja.org/forum/showthread.php?t=38139
I tried pulling one off with a pliers and it's hard as a mother to pull off.
Thanks for your help!
John V