lilwezel
NAXJA Forum User
- Location
- windsor,ontario,canada
in my 97 wrangler. it seems the driver front went bad and i new a new one. i do have the o3 laying around and if i can use it i would lke to.thanx
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
will the bearing hub from a 03 grand cherokee fit my dana 30
- Thread starter lilwezel
- Start date
The biggest issue you are going to have is the 03 Grand Cherokee uses a 5x5 bolt pattern, so it will not match the 5x4.5 of your XJ.
I also think the unit bearing is spaced away from the knuckle differently..
You might check with MJR on that, he would know..:anon:
I also think the unit bearing is spaced away from the knuckle differently..
You might check with MJR on that, he would know..:anon:
MJR
NAXJA Forum User
- Location
- Costa Mesa, CA
Mike is correct. WJ hubs are 5 on 5" bolt pattern compared to a XJ/YJ/ZJ/TJ which are 5 on 4.5". For a 97 TJ you can use a hub from a 90-98 XJ, 90-95 YJ, 93-98 ZJ, or a 97-98 TJ. These should be interchangeable.
