98 XJ Fog Light Switch removal

[Pioneer89XJ]

I searched the forum but can't find an exact answer to a really easy question. I have a 98 XJ Limited (faux wood dash trim). How do I get the trim off to the fog light switch? I can't find any screws like my 89 had. Thanks. :cheers:

[Special Ed]

It has no screws, the bezel just pulls off. The screws are underneath that hold the switch on.

[Pioneer89XJ]

Thanks Ed. I was thinking that it might just pull off but I wanted to make sure.

[RichP]

It pulls off from the BOTTOM corners, then you can take the top off. From there there are two screws holding in the plate. Don't break anything, it's only plastic.

[sweetjeep]

Yep.. just like everyone said. Bottom first, then top.

As for the switch itself, it's pretty self explanatory. If you don't have a new switch yet, you can take the switch apart and clean the contacts and put it back together (and have it work). It's a little tricky to put back together if I recall correctly, but it can be done.

[Pioneer89XJ]

I'll try to clean the switch up first. I really don't want to pay $30 for a switch from the dealer if I don't have to. Thanks again for all the info.

[Boris T]

I ended up wiring in another switch in it's place because I did not want to spend the money. After tearing the old switch apart I see why they go bad.... cheap poor design. :geek:
Travis