Cherokee91Red
NAXJA Forum User
- Location
- Charlotte, North Carolina
I have the RE6025 with poly bushings. The axle is rotating quite a bit, 1/4 to 1/2". Is this normal with the RE bushings or are they shot already?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
RE LCA bushing slop?
- Thread starter Cherokee91Red
- Start date
Fullsizexj
NAXJA Forum User
- Location
- Milton WV
There is a set screw on the side of the sleeve losen it and tighten up the bushing and then reseat the set screw, make sure to keep them lubed also
RCP Phx
NAXJA Forum User
- Location
- Phoenix,Az
The 6025 kit uses rubber bushings!But after what I saw this weekend makes me believe they have a vendor issue again!
http://www.naxja.org/forum/showthread.php?t=32439
http://www.naxja.org/forum/showthread.php?t=32439
Cherokee91Red
NAXJA Forum User
- Location
- Charlotte, North Carolina
Oh wasn't sure if poly or rubber. But with the LCA's the entire arm is moving inside the axle side arm mount. It acts like the sleeve is too big for the bolt or the mounting holes have widened. It seems like a shot bushing but they're only two months old so really don't think thats it.
