need flange part number CV to SYE

B

BUCKYXJ

NAXJA Forum User

Location

Tulsa, OK

• Jun 30, 2004

• #1

I need to convert my SYE to a CV shaft. anyone have the part number to do this? In other words I am gonna use a front shaft in the rear and need to adapter.

 

R

RCP Phx

NAXJA Forum User

Location

Phoenix,Az

• Jun 30, 2004

• #2

Have fun with this one!
http://www.gloeco.com/slip_yoke_eliminators.htm

 

Boatwrench

NAXJA Forum User

Location

Petaluma, CA

• Jun 30, 2004

• #3

Spicer p/n 211229x

Got this info from here: http://www.naxja.org/forum/showthread.php?t=28250

The post was started by john4w a couple of weeks back and titled "Using a non-RE shaft on RE hack-n-Tap"

Good Luck,
Tom

 

R

RCP Phx

NAXJA Forum User

Location

Phoenix,Az

• Jun 30, 2004

• #4

If your looking for the other end!
http://www.rockforddriveline.com/1310pg4.htm

 

S

sarvermr

NAXJA Forum User

Location

Little Rock, AR

• Jun 30, 2004

• #5

RCP Phx said:

If your looking for the other end!
http://www.rockforddriveline.com/1310pg4.htm

Click to expand...

which other end???

the axle end doesn't need anything. just bolt it up.

 

Dirk Pitt

Adam Dowling

Location

Salem, IN

• Jun 30, 2004

• #6

apparently this will work with dana axles, but will it work with my c8.25?

IIRC they all use the 1310 u-joint, right?

 

Jeepin Jason

NAXJA Member #1100

Location

Lewisville, TX

• Jun 30, 2004

• #7

Dirk Pitt said:

apparently this will work with dana axles, but will it work with my c8.25?

IIRC they all use the 1310 u-joint, right?

Click to expand...

Sure it will, doens't make any difference, the 8.25" and D35 both use 1310 yokes on the pinion.