jeepnchris
NAXJA Forum User
- Location
- Charlottesville, VA
Has anyone changed the bolt pattern on a XJ Dana 44 or know the following. I am changing the bolt pattern on my rear to 5 on 5.5. Dutchman wants to know. I thought they would know the dimensions. I could measure but would rather use someone elses measurements that worked. Many thanks for anyone that has these!
Chris
Measurements needed for the Dana 44 shafts.
Backing plate to backing plate (Driver to Passenger)
Ring and Pinion center to backing Plate
Axle Shaft Length (both sides)
Measure inner circle of bearing (where it rests on the shaft)
Flange diameter on the axle shaft
Outside of ridge of hole on outside of flange
Outside of flange to outside of bearing (Bearing side next to flange)
how wide the bearing is
Stud Size width
top of housing 4 bolts size that bolt brake to axel housing measure bolt center to center top to top and top to bottom)
inside diameter of axel housing
Chris
Measurements needed for the Dana 44 shafts.
Backing plate to backing plate (Driver to Passenger)
Ring and Pinion center to backing Plate
Axle Shaft Length (both sides)
Measure inner circle of bearing (where it rests on the shaft)
Flange diameter on the axle shaft
Outside of ridge of hole on outside of flange
Outside of flange to outside of bearing (Bearing side next to flange)
how wide the bearing is
Stud Size width
top of housing 4 bolts size that bolt brake to axel housing measure bolt center to center top to top and top to bottom)
inside diameter of axel housing