camber angle problem

hi, my xj have d44 front and 235/75 R 15, no lift

and the camber angle it's very negative

this problem have solution?

thanks!!

Rodrigo

Um yeah, STOP JUMPING IT! That's about the only cure for this problem.

The only way to FIX it is to find an old-time alignment shop that will heat & bend the tubes back where they should be. You can also try offset balljoints to adjust camber, but I doubt you'll get enough.

Good luck!

Off set upper ball-joints is probably the best option, but I think the most off-set you can get is 1.5 degrees. If this dosn't fix it and the axle is bent that bad you may want to start looking for a new axle housing. A severly bent axle will also abnormaly wear carrier bearings and gears, this is also something to keep in mind. Also you may want to !!!!!STOP JUMPING IT!!!!! Good Luck

ja ja ja ja OK OK, stop Jumping , thanks for the answers

Rodrigo :angel: