Front D.S. grease collar

JKTXJ

NAXJA Forum User

Location

Boise, ID

• Nov 19, 2003

• #1

I have managed to bang up and rip out the zerk fitting on the grease collar for my front driveshaft. Where can you get just a new collar and how do you replace them?? Doesn't want to just come off for me. Thanks, JP

 

JKTXJ

NAXJA Forum User

Location

Boise, ID

• Nov 20, 2003

• #2

Nobody??

 

Goatman

NAXJA Forum User

NAXJA Member

Location

Bakersfield, CA

• Nov 20, 2003

• #3

Mine's been smashed with the zerk ripped out for years. I fixed it once, but it only lasted one trip, so.......

Pull the shaft out and take it to a driveline shop. The last one I had replaced cost me $10.

 

JKTXJ

NAXJA Forum User

Location

Boise, ID

• Nov 20, 2003

• #4

Thanks, I'll check that out. Was hoping you could just buy one and there was some magic way to get that thing off. Oh well.
JP

 

R

RCP Phx

NAXJA Forum User

Location

Phoenix,Az

• Nov 20, 2003

• #5

If a Zerk is the only thing you took out,than an "easy-out" should make short work of that!

 

H

heepey

NAXJA Forum User

Location

Hardin, MT

• Nov 21, 2003

• #6

The grease collar is usually threaded onto the slip yoke. If not too banged up it should unscrew off