PDA

View Full Version : No turn signals after removing dash.


cbwymore
September 30th, 2017, 17:21
2000 XJ 4.0L auto

I removed my dash to replace heater core and A/C evap core, got it all back together but when I took it for a test ride the turn signals don't work and the flasher relay stays on (buzzes). The hazards don't work and the indicator lights do not come on either. Headlight, markers and brake lights all work.

I replaced the flasher relay and it stays on. Any assistance on where to start looking or a diagram on the turn signal system would be greatly appreciated.

Tim_MN
September 30th, 2017, 17:31
One might suppose that you did not fully seat a wire harness connector, re-check your work. Failure of the turn signal switch assembly is somewhat common, but logically if the signal worked before, and don't work now, either you forgot to plug in something, or possibly something like a wire or two got damaged.

cbwymore
September 30th, 2017, 17:56
Thanks. I pull all the trim around the steering column and it works now. Some thing must have been binding.