PDA

View Full Version : Help! 95 xj 4wd


Wykydtron95xj
July 27th, 2017, 18:45
I just finished installing a 3.5 Rubicon express superflex kit with 33in tires on my 95 xj. I double checked everything was torqued down and want to take it for a spin. When I started to pull out of my driveway it started jerking and clunking. Not sure what to make of it as it ran perfectly fine before the lift.
Any help on what to look at would be appreciated.

dan1977p
July 27th, 2017, 19:00
Did you mess with the transfer case linkage at all? Sounds like it could be stuck in 4wd.

Wykydtron95xj
July 27th, 2017, 19:19
No I didn't touch the linkage, at least not purposefully, How would I check it it was stuck in 4wd?. I put transmission in neutral when and let it roll back into the driveway and still same thing.

dan1977p
July 28th, 2017, 07:17
Ok, if straight line causes the problems, then it's not 4wd.
Take a bunch of pictures of the work done and post them up. Particularly around the driveshafts. If they are binding, it could cause this too. Have you rolled it with the driveshafts off?

cal
July 28th, 2017, 12:12
did you install a transfer case drop?

Wykydtron95xj
July 29th, 2017, 12:48
I'm going to try to get some pics uploaded tonight.
No I didn't do a transfer case drop. I ordered one yesterday should be here tomorrow to install.

trippled
July 29th, 2017, 13:15
Are the ears of the rear driveshaft touching at the t case? As in the 2 yokes making contact?