Rear axle pinion yoke question

I'm currently regearing a Dana 44 rear and it needs a new yoke. I researched to find OEM Spicer yoke 2-4-6561-1 was a direct replacement, but I decided I wanted to switch from straps to u-bolts on my yoke. So I searched more and found Spicer yoke 2-4-8091-1X which I thought was the same yoke, just with u bolts. But I noticed the 6561 yoke said it had a max operating angle of 28.5 degrees and the 8091 yoke was only 22.5 degrees. I can't find much more information about this angle, help!

Do you have a sye? This would be a non issue then.

they probably beefed the yoke up in the saddle, and the ears of the drive shaft will contact the yoke at that extreme angle.

you should be no where near that with any bolt on suspension.