xjdavid1
NAXJA Forum User
- Location
- Brisbane Australia
Does anybody know where I can get a thicker than normal Dana 44 wheel bearing retainer plate. I have a TJ 44.
Sent from my SM-N910G using Tapatalk
Sent from my SM-N910G using Tapatalk
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Dana 44 wheel bearing retaining plate
- Thread starter xjdavid1
- Start date
- Location
- San Diego
Why thicker? There are tj specific ones that have a lip as opposed to the flat xj ones
- Location
- Hammertown, USA
http://www.4wheelparts.com/Drivetra...r.aspx?t_c=12&t_s=514&t_pt=9176&t_pn=D/S51762
As was stated, not thicker, just has an extra flange on it.
As was stated, not thicker, just has an extra flange on it.
xjdavid1
NAXJA Forum User
- Location
- Brisbane Australia
Looking for a stronger one as suspect mine is flexing.
Sent from my SM-N910G using Tapatalk
Sent from my SM-N910G using Tapatalk
- Location
- Hammertown, USA
they are supposed to flex a little bit.
They bend a little and set the preload on the wheel bearing.
They bend a little and set the preload on the wheel bearing.
xjdavid1
NAXJA Forum User
- Location
- Brisbane Australia
what seal have you found to be the best.
Sent from my SM-N910G using Tapatalk
Sent from my SM-N910G using Tapatalk
- Location
- Hammertown, USA
I don't know that it matters. I always use the ones that come with new axle shafts.
