axle shims

[tomwest49]

I just installed a 2" budget lift on my xj I'm getting a little vibration from the drive shaft. Will an axle shim fix the problem and if so what degree shim should I use?

[roXJeepr]

This should be posted on a Tech Forum. You'll need to figure out what the difference is between the front and rear(of the rear shaft) driveline to yoke angles. I believe it usually takes about a 2 or 3 degree shim in your application.

OK where's the tech forum for NAXJA. Oh you mean I have to go outside of NAXJA to get answers about XJs.

[Jim 01XJ]

No, you don't have to go outside of NAXJA, but you are in the South East Chapter Forum. What you need is right here http://www.naxja.org/bbs/tech.cgi